Slim coolrunner install

Now available in packs for PRO installers! Customers Also Bought Customer Reviews. Recently Viewed. Control Panel. Wish list. Authentication Sign in Register Forgot password? News No news available at the moment.

Affiliates Click here to register as an affiliate. RSS Feeds. We deal in aftermarket parts and do not represent and expressly disclaim any association with any manufacturer, distributor or vendor of any product referred to on this website. Add a personal message. Send to friend. Wii-U Replacement Drive. Extremely professional , I ordered an Item that was discontinued, The rep sent me an email of what I would like to do I chose to get a coupon that I did not use for a few months..

I guess the item I wanted is back so I put in the order and the coupon code all I had to do is pay shipping I was so happy every thing went smoothly and they send me my item I have used them and only them great service, Happy To be your customer thanks.

After testing the laser, I discovered it also needed replacing. Lacking parts, I took the remaining time to analyze the board and inspect all of the hardware mounting and soldering points for both the Coolrunner and DemoN install.

Everything looks original and unmolested!. Phase 2. Now that all of the equipment arrived I began the initial steps. Most of these don't have pictures, as they are fairly straight forward.

There are number of potential issues along the way that can cause all kinds of grief. Use only as much solder as is needed, it is far too easy too use too much and short contacts.

Tape or glue wires down that are soldered directly to the board to avoid ripping out pads. Also, verify that you have all of your wires and quick solder points soldered down. They are easy to miss! If this still doesn't work, check with a multimeter for power at the DemoN board.

Then check all of your solder points to verify they aren't shorting with any other pads. If you are having trouble reading the nand, you likely have an issue with the QSB points that are all in a row. Other than that, there's little that can mess up or cause problems with the DemoN. Once it is soldered correctly, it pretty much works or doesn't.

The CoolRunner can be extremely frustrating. Start by making sure the switch is in the 'NOR' mode. Then, verify the red light comes on whenever power is applied to the unit usually standby power should turn it on. Next, try to identify if it is attempting to glitch or not.

If you power on, and you never see the green debug led flash and the xbox doesn't make the tell-tale fan stuttering sign, chances are the CR isn't attempting to glitch. If you are still having problems, verify all solder points and try to route the blue D wire away from any coils, ground, or power wiring.

I had to run mine back over the board towards the center of the CR to avoid interference for the best glitch results. Community Forum Software by IP. Board Licensed to: Left 4 Modz. Sign In Create Account. Welcome to Left 4 Modz Register now to gain access to all of our features. Once registered and logged in, you will be able to create topics, post replies to existing threads, give reputation to your fellow members, get your own private messenger, post status updates, manage your profile and so much more.